What To Do If - IKEA FRYSA Serie Mode D'emploi

ENGLISH

What to do if ...

Problem
The control panel is switched off, the
appliance does not work.
The internal light does not work.
The temperature inside the
compartments is not cold enough.
There is water on the bottom of the
refrigerator compartment.
F
The red icon is flashing and a sound
signal is activated
F
The red icon will light up, a sound
signal is activated and the letter "F" is
flashing on the display.
Before contacting the After-Sales Service:
Restart the appliance to see if the fault has been remedied. If it
persists, switch the appliance off again and repeat the operation
after an hour.
If your appliance still does not work properly after carrying out
the checks listed in the troubleshooting guide and switching
the appliance on again, contact the After-sales Service, clearly
explaining the problem and specifying:
• the nature of the problem
• the model
Possible causes:
The appliance may be in On/Stand-by
mode.
There may be an appliance power supply
problem.
The light may need replacing.
The appliance may be in On/Stand-by
mode
There could be various causes (see
"Solutions")
The defrost water drain is obstructed.
The drain hose is not in the compressor
tray
Door open alarm
It is activated when the door remains
open for a prolonged period of time.
Malfunction alarm
The alarm indicates the malfunction of a
technical component.
Note:
Gurgling, hissing and humming noises from the refrigerating system are
normal.
• the type and serial number of the appliance (given on the
rating plate)
• the Service number (the number after the word SERVICE on the
rating plate inside the appliance).
Note: if the direction of door opening is reversed, this operation
is not covered by the warranty.
Solutions:
Turn the appliance on pressing the On/
Stand-by button. Check that:
- there is not a power outage
- the plug is properly inserted in the
power socket and the mains double-
pole switch (if present) is in the correct
position (i.e. allows the appliance to be
powered)
- the household electrical system
protection devices are efficient
- the power cable is not broken.
- Models with LED lights: contact the
authorised Technical Assistance Service.
- Turn the appliance on pressing the On/
Stand-by button
Check that:
- the door close properly
- the appliance is not installed near a heat
source
- the set temperature is adequate
- the circulation of air through the
ventilation grilles on the base of the
appliance is not obstructed.
Clean the defrosting water drain (see
section "Maintaining and cleaning the
appliance")
Check that:
• The tube is correctly inserted in the tray
To turn the sound signal off, close the
door of the product.
Call the authorized Technical Assistance
Service. To turn the sound signal off,
briefly press the "Turn off sound alarm"
button
10