Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ABB-Welcome M
Mounting / Installation
Connect the bottom part of the device according to the graphics (see chapter
"Connection").
Setting
Set the address of the preferred outdoor stations and the address of the indoor station
on the rotary switches.
Set the master/slave function and the terminal resistor on the switches at the rear of the
Terminal Resistor
top part of the housing (see chapter "
").
Latch the device
Latch the upper part of the device onto its bottom part: place the upper side of the
device on the lock-in lugs and then press the bottom side onto the bottom part of the
device until it is caught by the clamp.
|
— 59 —
Publicité
Table des Matières
