Uline H-437 Guide Rapide

H-437
MINI-BASE HANDWRAPPER
Figure 1
TO LOAD FILM ONTO HANDWRAPPER
NOTE: Handwrapper comes preset at 12" height.
Must unthread completely to use larger rolls.
1. Unscrew the top handle (turn counterclockwise)
about 1/2 inch. Remove the slotted top core holder by
sliding it out of the threaded rod section. (See Figure 1)
2. Slide the film roll over the top handle and position
the film core over the bottom core holder.
3. Take the top core holder and slide it back through the
threaded rod section. Drop it into the top of the core.
4. Screw the top knob clockwise until it holds the top
core holder in place.
PAGE 1 OF 3
LOADING AND UNLOADING INSTRUCTIONS
Handle Assembly
(Washer, Bearing,
Threaded Rod)
Top Core Holder
Threaded Rod Section
Bottom Core Holder
1-800-295-5510
uline.com
Top Handle
TO REMOVE FILM FROM HANDWRAPPER
1. Unscrew the top handle (turn counterclockwise)
about 1/2 inch. Remove the slotted top core holder by
sliding it out of the threaded rod section. (See Figure 1)
2. Remove the film by sliding it over the top knob.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0721 IH-437