Uline H-4025 Mode D'emploi

H-4025
GREEN MACHINE
AIR PILLOW MACHINE
TOOLS NEEDED FOR MAINTENANCE
4mm Allen 3mm Allen
Wrench Wrench
The Uline Green Machine converts rolls of pre-perforated,
sealed flat tubing into air cushions for use as void fill
packaging.
CAUTION! For safety reasons the cushions are
to be used ONLY as a packaging material and
MUST NOT be used as a flotation aid, a toy or
for other unspecified use.
Operators must never use the machine other than as
specified by the instructions in this manual.
1. Removal of the front cover will void the warranty.
2. Keep hands away from all moving parts while
operating machine.
3. The machine will automatically shut down in the
event of a jam. To restart the machine, clear the jam
and press reset. Press the start button to restart.
4. Do not place flammable materials over the heat
sealing section.
PAGE 1 OF 15
1-800-295-5510
uline.ca
Needle Nose
Pliers
SPECIFICATIONS
TECHNICAL SPECIFICATIONS
Machine Dimensions (L x W x H)
Machine Weight
Power Supply
Film Material
Roll Length
Roll Width
SAFETY INSTRUCTIONS
5. In the event of an emergency, press the red
6. If the machine is to remain inactive for longer
Pour le français, consulter les pages 11-15.
emergency stop button. To restart the machine,
rotate the emergency stop button so that it springs
out to the normal operating position.
NOTE: THE EMERGENCY STOP BUTTON IS ONLY TO
BE USED FOR EMERGENCIES. For normal start
and stop, use the start/stop button.
periods of time, the machine should be switched
off using the main power switch located where the
power cable enters the machine.
Para Español, vea páginas 6-10.
14 x 12 x 11"
19 lbs.
110V
High-Density Polyethylene
Tubing
1,640' or 1,066'
8" or 16"
0221 IH-4025