CANARMNA LOL386 Manuel D'utilisation

SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Electrical
Box
Hex nut
Mounting
Bracket
Nipple
Electrical Box Screws
(not included)
House
supply
Ground
wire
Black
Fixture
Ground
White
wire
LED OUTDOOR
LIGHTING
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
1.
Attach nipple to
mounting bracket. Adjust so
it will clear hole in back of
fixture and then lock nipple
in place with hex nut. Attach
mounting bracket to electrical
box with electrical box screws
(not included).
2.
Connect the ground wires
(bare copper or green) from your
fixture to the ground wire (bare
copper or green) or ground screw
in the electrical box. Connect the
black wire from the fixture to the
black wire in the electrical box
and connect the white wire from
the fixture to the white wire in the
electrical box.
NOTE: Do not disconnect any
pre-wired connections.
3.
Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
electrical box making sure no bare
wire (on the black and white) is
visible at the wire nuts.
Tel: (613) 342-5424, Fax: (800) 263-4598
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Pliers
LOL386
Cap Nut
4.
Position hole in fixture over nipple and secure in
place with cap nut.
LOL386
5.
Position glass inside guard and place on fixture.
Secure in place with two screws and tighten until
gaskets seal.
Weather Resistant
Caulking
(not included)
6.
After installation, seal around the side perimeter
between the fixture and the wall or ceiling surface
with weather resistant caulking (not included).
LOL386
LOL387
09/18
Wiring supplies
Wire Cutters
as required by
local electrical
code
Wrench
LOL387
LOL387
Glass
Guard
Screw