Technical Data And Characteristics - Ferroli ATLAS D ECO 30 K 100 UNIT Instructions D'utilisation, D'installation Et D'entretien

Masquer les pouces Voir aussi pour ATLAS D ECO 30 K 100 UNIT:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 56
ATLAS D ECO 30/42 K 100/130 UNIT
Circulating pumsp diagnostics
Some faults linked to the circulating pump are signalled by the LED located around the
speed selector (fig. 41 - fig. 42).
Table. 5 - Circulating pump LED indications
Off
Min
.
Circulating pump on STANDBY
1
I
4
II
7
III
Green ON
Circulating pump Working
Green Flashing
Air venting cycle
Green/Red alternating
Circulating pump blocked due to external causes:
- Overvoltage (>270V)
- Insufficient voltage (<160V)
- Motor overload
Red Flashing
Circulating pump blocked due to internal causes:
- Motor blocked
- Damaged electronics
Circulating pump diagnostics (model PARA)
Some faults linked to the circulating pump are signaled by the LED (fig. 42).
LED
Fault
Fault
On with red light
Contact/winding
Under/overvoltage
Excessive module tem-
Flashing with red light
perature
Short circuit
Turbine operation
Dry running
Flashing with red/
green light
Overload
fig. 41
fig. 42
Cause
Cure
Blocked rotor
Activate manual restart or
Faulty winding
contact Customer Service
Supply side voltage too low/high
Check the mains voltage and
Inside of module too hot
conditions of use.
Request Customer Service
Motor current too high
The hydraulic system of pumps
is fed but the pump does not
have mains voltage
Air in pump
Check the mains voltage, the
The motor turns with difficulty.
water flow/pressure as well as
Pump operation not in accord-
the environmental conditions
ance with specifications (e.g.
high module temperature).
The speed is lower than in nor-
mal operation.
cod. 3541Q564 - Rev. 01 - 11/2022

5. TECHNICAL DATA AND CHARACTERISTICS

Key of figures cap. 5
A
Safety and non-return valve
A4
Fume outlet
10
System delivery - Ø 3/4"
11
System return - Ø 1"
14
Heating safety valve
32
Heating circulating pump
36
Automatic air vent
40
DHW expansion vessel
56
Expansion vessel
74
System filling cock
97
Magnesium anode
130
Hot water tank circulating pump
143
Hot water tank control thermostat
154
Condensate drain pipe
178
Hot water tank thermometer bulb
179
Non-return valve
180
Hot water tank
192
Recirculation - Ø 3/4"
197
Manual air vent
209
Hot water tank delivery - Ø 3/4"
210
Hot water tank return - Ø 3/4"
233
Hot water tank drain cock
246
Pressure transducer
275
Heating system drain cock
278
Double sensor (Heating + Safety)
293
Hot water tank inspection flange
295
Burner
5.1 Dimensions, connections and main components
40
295
74
97
42
233
fig. 43 - Front view
500
32
246
130
179
293
180
275
EN
49

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Atlas d eco 42 k 130 unit

Table des Matières