Installing With Base - Joie gemm Manuel Utilisateur

Correctly assembled vehicle
safety belt is shown as
27
!
Lap belt must pass through
the two side guides,
as -1.
27
!
The vehicle buckle is locked
correctly, as -2.
27
!
Diagonal belt must pass
through the rear guide,
as -3.
27
ii. Installing with Base
see images -
28 34
1. Unfold the load leg from
storage compartment.
2. After placing the base on the
vehicle seat, squeeze load leg
adjustment button to extend
the load leg to floor
29
the load leg indicator shows
green means it is installed
correctly, red means it is
installed incorrectly.
29
!
The load leg has 8 positions.
When the load leg indicator
shows red this means the
load leg is in the wrong
position.
!
Make sure the load leg is
secure by pressing down on
the front of the base.
17
27
.
1
2
28
28
-1,
29
1
-2
2
3. Open the lock-off and route the vehicle safety belt through
the belt path
4. Tighten the vehicle safety belt as much as possible while
pushing down on the base, and check it is not loose or
twisted.Close the lock-off.
!
Check that the safety belt does not move by pulling and
3
pushing hard on base. If belt loosens or lengthens,
repeat procedure.
30
1
2
The installed base is shown as
!
Please ensure that there is
no gap between the seat and
the bottom of the base.
!
The safety belt must go
under the lock-off
not over the lock-off.
-1, and lock it into the buckle
30
-3
30
.
31
31
-1,
31
-2
31
-2.
30
3
1
2
18