Installing With Base; Installing With Stroller - Joie juva Manuel D'utilisateur

2. Slide diagonal belt into the rear guide.
3. Pull the belt to fasten the infant child restraint tightly and
securely. (Fig. 23)
!
Tension the vehicle safety belt as much as possible,
check that it is not loose or twisted.
!
The vehicle safety belt shall not cause pressure on any
part of the child.
Correctly assembled vehicle safety belt is shown as
!
Lap belt must pass through the two side guides,
as Fig. 24.1
!
The vehicle buckle is locked correctly, as
!
Diagonal belt must pass through the rear guide,
as Fig. 24.3
ii. Installing with Base
1. Unfold the load leg from storage compartment.
2. After placing the base on the vehicle seat, squeeze load leg
adjustment button to extend the load leg to floor
the load leg indicator shows green means it is installed
properly, red means not.
!
The load leg has 8 positions, the load leg indicator shows
red means the load leg is in a wrong position.
!
Make sure the load leg is secure by pressing down on the
front of the base.
3. Open the lock-off and route the vehicle safety belt through the
belt path (Fig. 27.1), and lock it into the buckle
23
(Fig. 22)
Fig. 24
Fig. 24.2
(Fig. 25)
(Fig.
(Fig. 26.2)
(Fig. 27.2).
4. Tension the vehicle safety belt as much as possible while
pushing down on the base, and check it is not slack or twisted.
Close the lock-off.
!
Check the safety belt does not move by pulling and
pushing hard on base. If belt loosens or lengthens,
repeat procedure.
The installed base is shown as
!
Please ensure that there is no gap between the seat and
the bottom of the base.
!
The safety belt must go under the lock-off
not over the lock-off.
5. Push the child restraint down into the base
restraint is secure, the child restraint indicator shows green, or
else shows red.
!
Pull up on the child restraint to be sure it is securely
latched into the base.
!
The child restraint can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the base
securely.
6. To release the child restraint, pull the child restraint up while
squeezing the child restraint release button.
26.1),
iii. Installing with Stroller
Your infant child restraint is designed to attached to certain joie
stroller models featuring a special tray, armbar or calf support.
!
Please make sure your stroller can fit the infant child restraint
before purchasing it.
!
Never allow more than one baby in the travel system
at one time.
(Fig. 27.3)
Fig. 28
(Fig. 28.2)
(Fig. 30)
(Fig. 30.1)
(Fig. 28.1),
(Fig. 29), if the child
(Fig. 31)
24