Infant Child Restraint Installation; Installing Without Base - Joie juva Manuel D'utilisateur

! Use extreme care in threading the shoulder harnesses
according to the figure. If the shoulder harnesses are not
secure, they will not protect your baby properly.
Securing Child
Restraint
Note
1. Insert is for infant's protection. Infant weighing under
10kg must use the insert A or B.
2. If the accessory is insert A, please assemble the foam
before using the insert.
3. After child is placed into the seat, check whether the
shoulder harnesses are at proper height.
1. Lift the cover of adjustment button.
2. While pressing the adjustment button located at the front of
the infant child restraint, pull completely the two shoulder
harnesses of the infant child restraint.
3. Unlock the buckle of the harnesses by pressing the red
button. (Fig.16)
4. Place child into the infant child restraint and lock the buckle.
(Fig. 17& 18)
5. Tension the shoulder harnesses by pulling adjustment
webbing. (Fig. 19)
!
Make sure the space between the child and the shoulder
harnesses is about the thickness of one hand.
21
in the Infant Child
(Fig. 13)
(Fig. 7)
(Fig.14)
(Fig. 15)
Infant Child Restraint
Installation
The infant child restraint can be used with the base and certain
joie strollers. The installation instructions vary depending on
whether or not you are using the base or stroller. Please refer
to the proper section.
!
Do not place the infant child restraint on front vehicle seat
with airbag. Death or serious injury can occur.
!
When use the infant child restraint in a vehicle seat, please
adjust the handle to position 1.
!
Face your child restraint or base toward the rear of the
vehicle.
!
Ensure the vehicle safety belt is not slack or twisted.
!
Always fasten the harness of your child restraint securely
on your infant, regardless of how it is being used.
i. Installing without Base
After fitting the harness to your child and determining which
rear vehicle seat location is best, you are ready to install your
infant child restraint.
1. Place the infant child restraint onto the vehicle seat where
you wish to put it, pull the vehicle safety belt and slide the
lap belt into the two side guides of the infant child restraint,
and lock it into the buckle.
!
The child restraint can not be used if the vehicle safety
belt buckle (female buckle end) is too long to anchor the
child restraint securely.
(Fig. 20)
(Fig. 5.1)
(Fig. 21)
(Fig. 21.1)
22