Choose The Installation Mode; Recline Adjustment; Height Adjustment; Baby Mode - Joie every stage fx Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Product
Child Restraint
Model
C1602
Suitable for
Child weighing 0 - 36kg (approximately 0 - 12 years)
Mass Group
0+/1/2/3
Materials
Plastics, metal, fabrics
Patent No.
Patents pending

Choose the Installation Mode

Child's
Installation
Figure for
Weig ht
Mode
Installation
0 -18 kg

Baby mode

Toddler
9 - 18 kg
mode
15 - 36 kg
Junior mode
7
Reference
Seat
Infant Insert
Instructions
Age
Position
Infant insert
must
Position 5- 6
be used from
birth -
0-9 months
4 years
to help restrain
the child tightly
When installing
Position 1 - 4
the child restraint
1 year
In the toddler
to
mode, do not
4 years
use the
infant insert.
When installing
Position 1 - 4
the child restraint
3 years
In the junior
to
mode, do not
12 years
use the
infant insert.
Important
1. DO NOT use forward facing mode before the child's weight exceeds 9kg.
2. When the child is suitable for both toddler and baby modes, it is recommended to install this child
restraint in the baby mode as it is relatively safer.
Use Side Impact Shield
1
see images
!
Must open the side impact shield to protect the child more safely. The side impact shield opposite to the
vehicle door can be closed to allow more seating space.

Recline Adjustment

2
see images
Choose the proper seat position referenced in the previous table (page 7) and press the adjustment handle to
adjust the recline 3
!
Make sure that vehicle seat belt will be retightend when adjusted in reclining position and vice versa if seat was
already buckled up properly previously.

Height Adjustment

for Head Support and Shoulder Harnesses
3
see images
Please adjust the head support and shoulder harnesses to proper height according to the child's height.
!
When used in baby mode, the shoulder harness height must be even with or just below child's shoulders.
!
When used in toddler mode, the shoulder harness height must be even with or just above child's shoulders.
-2
3
!
When used in junior mode, the shoulder belt guides must be even with child's shoulders.
Squeeze the head support adjustment lever, meanwhile pull up or push down the head support until it snaps
into one of the 10 positions.
Side wings are able to open while the head support is adjusted to the 6 th position.
!
Baby Mode
(Rearward Facing Mode/for Child under 18kg)
see images
-
4
12
!
Please install the child restraint on the rear vehicle seat and then put the child in the child restraint.
i. Installation for Baby Mode
1. Pass the waist belt over lap belt guidings, and then engage the vehicle buckle tongue into the buckle.
2. Fasten the shoulder belt in the two shoulder-belt slots at the back of the child restraint.
!
8
Shoulder belt must pass through the Lock-off
3. While pressing the child restraint, pull the belts to fasten the child restraint tightly and securely.
!
The child restraint can not be used if the vehicle safety belt buckle (female buckle end) is too long to anchor
the child restraint securely.
3
-3
7
.
9
3
-1
5 6
8

Publicité

Table des Matières
loading

Table des Matières