Detaching Soft Goods - Joie juva Manuel D'utilisateur

!
Please brake your stroller before assembling the
infant child restraint.
!
Check the parts that are used to fix the infant child
restraint are securely fastened on the stroller.
!
Recline the stroller seat back to the lowest position.
To assembling the infant child restraint on Joie strollers,
please follow these steps:
1. Place child restraint into stroller so notches in rockers fit
over edge of armbar, tray or calf support. The child restraint
will then automatically click into place.
( Fig. 32 & 33 & 34 & 35)
!
If armbar has fabric cover, please detach the velcros on
armbar cover first. (Fig. 34.1)
!
For the stroller with a special calf support, please adjust
the calf support to the vertical position, detach the
velcros, and then lift the fabric cover.
2. Using the straps on both sides of stroller to fix the child
restraint. ( Fig. 36)
!
Try pulling the child restraint upwards to check that it is
fitted correctly.
To remove the child restraint, release the straps from the child
restraint, pull up the stroller fix release button B to release the
child restraint from tray, armbar or calf support, and then lift
child restraint out of stroller, please refer to
!
If you have any problems about using these strollers,
please refer to their own instruction manuals.
25
(Fig. 35.1)
Fig. 37

Detaching Soft Goods

Soft goods include canopy, seat pad, shoulder pads and
crotch pad.
1. Remove the canopy by unsnaping the snaps.
2. Remove the safety buckle from the crotch pad.
3. You must remove the shoulder harnesses and shoulder
pads. To do this please refer to the section 'Shoulder
Harness Height Adjustment'.
4. Pull out the fastening pieces underneath the edge of the
seat. (Fig. 39)
To refit the seat pad simply reverse the steps above, however
make sure that the shoulder harnesses are not crossed over
and not twisted.
(Fig. 38)
26