Panasonic DVCPRO AJ-BS900P Mode D'emploi page 5

Parts and their functions
Front panel
9
Intercom XLR connector
This is used to connect a headset to the intercom.
:
PGM level knob
This knob is used to adjust the volume of the PGM audio
mixed into the signal fed to the intercom headset.
;
SYSTEM/PRIVATE selector switch
This is used to toggle the intercom between the system and
private modes.
SYSTEM: The intercom is connected to the system via the
communication connector on the rear panel of
the unit.
PRIVATE: The intercom is not connected to the system via
the communication connector on the rear panel
of the unit.
<
INTERCOM level knob
This knob is used to adjust the volume of the microphone
input to the intercom.
=
MIC button
This button is used to switch the intercom microphone on and off. It has three positions: ON, OFF, and PTT. (PTT: Audio
transmission continues as long as the button is held down.)
>
Phase adjustment switch
The available settings are SC PHASE, OFF, and H PHASE.
SC PHASE: Selects SC phase adjustment.
OFF: No phase adjustment is performed.
H PHASE: Selects H phase adjustment.
?
Phase adjustment buttons
These buttons are used to adjust the phase selected using the phase adjustment switch >.
@
GEN LOCK indicator
This indicator lights when the camera's synchronization is locked using the signal input via the GEN LOCK connectors on the
rear panel.
<Note>
This indicator blinks if there is something wrong with the GEN LOCK signal. When this happens check the GENLOCK signals.
RIAX
>
<
:
ON
OFF
- 4 -
@
VTR
ENABLE REW
GENLOCK
ON
SC OFF H
PHASE PHASE
OFF
?
SET UP
INTERCOM
MIC
(PUSH)
=
ON
OFF
PTT
MON SEL
PGM
SYSTEM
B SUP
G ;
R
PRIVATE
KNEE
POINT
PUSH
KNEE
SLOPE
9