Lux Learning Function With Knob - koban KDP5 Mode D'emploi

Lux learning function with
knob
Learning procedure:
• Adjust the knob to "
the ambient light level matches
with the desired value (See
FIG.20-A).
• When the knob is set to "
originally, it should be adjusted
to other position more than 1
sec, then goes back to "
(See FIG.20-B).
• Then the load is off. LED starts to
flash slowly indicating entering
into learning mode. Learning will
be completed within 25 seconds.
Afterwards, the LED and load
will keep on 5sec or LED flashes
quickly for 5sec and load is off
to confirm successful learning
(See FIG.20-C).
• After learning procedure, the
detector returns to AUTO mode
with LED and load being off.
www.grupotemper.com
Highbay presence detector
2000
" when
300
Adjust knob to
"
"
other position
"
2000
300
FIG.20-A
LED and load keep on 5sec
(the actual light level range
is 10 - 2000Lux)
2000
300
100
10
Adjust knob to
100
other position
from "
" from 2000
300
100
1sec after, goes
10
back to " "
100
2000
300
100
FIG.20-B
W
LED flashes slowly for 25sec
& Load is off
W
LED flashes quickly for 5sec &
Load is off (the actual light
level range is out of 10 -
2000Lux)
W
LED and load off
Detector switches to AUTO mode
FIG.20-C
Instructions manual |
KDP5
10
"
10
10
W
67