koban KDP5 Mode D'emploi page 56

KDP5
Highbay presence detector
• A light detecting sensor is built-in for setting the desired light level to
switch on the controlled lighting automatically at the right timing to
maximize energy savings and save more of your electricity expense.
• Various mounting methods, including ceiling flush mounted with spring
clips KDP5/3 power box cap directly or combined with the existing
European standard junction box and ceiling surface mounted with the
KDP5/3 junction box.
• Except the provided Lux values, the ambient light level can be read-in
either by IR or knob as the threshold for switching on / off the loads for
more flexible application.
• An additional function of manually switching on / off the controlled load is
feasible by connecting to a push button switch.
• IR remote control is available for easy and quick settings
Characters of high frequency presence detector
• High frequency sensor is able to penetrate non-metallic materials such as
the wood board, brick wall, glass, etc., but it can not penetrate the water
and metal.
• High frequency presence detector has high reliability and its detection
range is less affected by temperature (0°C to +45°C), airflow, wind, etc..
• The humidity, vibration as well as measurement of moving object can weak
the performance of high frequency detector.
• It is easy to be false triggered because of its strong penetrability of non-
metallic materials and high sensitivity. It should be more careful while
choosing the location of detector.
The high-frequency output of radar module is <1mW; approximately just
0.1% of the transmission power of a mobile telephone or the output of a
microwave oven.
Instructions manual |
< 1mW
56
Approx. 1000mW
www.grupotemper.com