Installation Procedure - koban KDP5 Mode D'emploi

KDP5
Highbay presence detector

Installation procedure

Flush mount with European standard junction box
• Take off decorative frame of KDP5, then take the detector head apart from
power box by unscrew its 4pcs non-dropping screws (See FIG.9).
Detector head
• Pull out AC power cables from
European standard junction box then
strip off 6 - 8mm of cable sheathing
for wiring (See FIG.10 ).
• Fix the power box into European standard
junction box with 2pcs screws (See FIG.11).
Instructions manual |
FIG.9
62
Power box
Non-dropping
screw
Decorative
frame
6 - 8mm
30 - 35mm
FIG.10
FIG.11
www.grupotemper.com