Dimplex DFB4047 Manuel Du Propriétaire page 12

Operation
Figure 4
ON
Button
OFF
Button
Battery
Resetting the Temperature
Cutoff Switch
The heater is protected with
a safety device to prevent
overheating. should the heater
overheat, an automatic cut out
will turn the heater off and it will
not come back on without being
reset. It can be reset by switching
the on/off switch to off and
waiting five (5) minutes before
switching the unit back on.
CAUTION:
continuously cuts out, unplug the
unit and call customer service at
1-800-DImPLEX.
Remote Control
The fireplace is supplied with an
12
Battery
Cover
If the unit
(Figure 4)
integrated on/off remote control,
that is factory syncronized with
the firebox.
To operate, push the on button
to turn fireplace on, push the oFF
button to turn the fireplace
The amount of heat produced will
be dependant on positioning of
manual heat controls.
!
NOTE: Ensure that the
fireplace's on/off switch is set
to the remote control setting ("
II " position).
Initialization/Reprogramming
Follow these steps for remote
control initialization if required:
1. set the main power switch to
OFF ("O"). (Figure 3A)
2. Wait a minimum of five
(5) seconds and set the 3
Position switch to the remote
position ("II").
3. Within 10 seconds of re-
acquiring power, press the
on button located on the
remote control transmitter.
!
NOTE: You will have only 10
seconds to perform this last
step. Failure to do so will
result in these steps needing
to be followed again.
This will synchronize the remote
control transmitter and receiver.
off.
www.dimplex.com