Publicité
Les langues disponibles
Les langues disponibles
This is where you'll find the complete settings/options available to configure your own radio tuner. When in the main menu,
navigate to Configuration setting. Press <OK> and you will see a list of available options.
Network
•
Network options
Always on: The WLAN function remains switched on (faster access when switching from DAB or FM mode to Internet
radio).
Auto off in 30s: The WLAN function shuts down after 30 seconds when not in use (to save energy).
•
Wifi channels
Not all of the Wi-Fi channels are available in every country. There may be variation between different countries.
Therefore it is necessary to choose the Wi-Fi channels to ensure the Wi-Fi performs satisfactory. We have already set
the channels according to the requirement in different countries. Choose the country you are staying from the list to
get the correct channel. The Europe/United Kingdom is set by default, press <OK> on the Remote control or push the
<Tune/Select> knob to edit the country selection.
•
WiFi network
Add / remove AP
o
Add AP - It will scan for routers in your area.
Add AP (WPS) - Select this option for connecting your WiFi-router via WPS (if the router has a WPS button).
Add AP (SmartConfig) - Choose this option to configure the WiFi network with a smart phone through an
app. It is available on iOS App Store and android play store. Search and install the app "Esptouch".
Have your smart phone connected to the same WiFi network which the radio is also connected to. It is
recommended to place the radio within 2 meters from your router for the highest possible success rate.
Follow the steps below:
1.
On the radio: navigate to Configuration>Network>Add/Remove AP>Add AP (SmartConfig) and press
<OK> to confirm.
2.
Launch the App on your smart phone.
3.
The name of the SSID (your WiFi-network) will appear as below.
4.
Enter the WiFi password.
Tap Multicast, followed by Confirm to complete the setup.
5.
The radio will start associating with the network, the message "Association complete" will appear when
6.
the connecting is successful.
Remove AP - Choose this option if you have already added a router and want to delete it.
AP [ ]
o
If you have added more than one router and want to switch between them, select this option.
Signal
o
This is to show the strength of the signal of the Wi-Fi router as received by the radio. Usually signal levels
lower than -70dBm is at weaker level and if it affects the reception of your radio, you may need to optimize
the router location or check any problem of the router itself.
IP
o
The IP is set to Dynamic by default. Select to change the Fixed IP according to your network condition.
DNS
o
The DNS is set to Dynamic by default. Select to change the Fixed DNS according to your network condition.
11
Publicité
