For Your Safety - Würth ALG 12/3 BASIC Traduction Des Instructions De Service D'origine

GB
WARNING
Read all safety warnings and
all instructions. Failure to follow the warnings and
serious injury.
Save all warnings and instructions for future
reference.
Please read and observe these instructions before
using the product. Failure to follow these instructions
and warnings increases the risk of electric shock,
Do not recharge primary cells
WARNING
(non-rechargeable).
This appliance is not intended to
WARNING
be used or cleaned by persons with reduced
physical, sensory or mental capabilities, or
lack of experience or knowledge, unless they
have been given instructions concerning the
safe use of the appliance by a person legally
responsible for their safety. They should
be supervised whilst using the appliance.
Children shall not use, clean or play with this
appliance, which when not in use should be
secured out of their reach.
If the supply cord is damaged,
WARNING
it must be replaced by the manufacturer, its
order to avoid a hazard.
WARNING
Mains voltage must correspond with
Before using the product, check that the product
enclosure, cable and adaptor plug are not
damaged. If damage is found, do not use and
follow instruction in the maintenance section of this

For Your Safety

possible only when the operating
and safety information are read
completely and the instructions
contained
followed.
manual.
The product must not be damp, and should never
be used in a damp environment.
The product is for indoor use only.
shock or jolting, or is damaged in any other way.
Do not conduct charging in a position which may
become exposed to sunlight or other heat source.
Due to the heat generated during charging, the
product should not be operated on a combustible
surface.
Do not conduct charging operations in the vicinity
materials, paint, spray paint or aerosols, lubricant,
thinners, petrol containers, gas containers or gas
appliances.
Do not cover any ventilating slots and provide
adequate ventilation during operation.
Never modify, disassemble or attempt to repair the
product yourself.
Do not allow the charger or batteries to become
contaminated with any material which could
be conductive. Example: Metal particles from
grinding, cutting or machining processes.
Remove the plug of the product from the power
socket when it is not in use or when cleaning it.
Only use extension cable that is approved and in
good condition.
Protect battery contacts to avoid a short circuit
or explosion!
therein are strictly
10