Napoleon PVA-58ASCENT Instructions D'installation

THESE INSTRUCTIONS ARE TO BE USED IN CONJUNCTIONS WITH THOSE FOR THE GPV AND THE APPLIANCE.
THIS INFORMATION SUPERSEDES THAT IN THE APPLIANCE INSTALLATION INSTRUCTIONS.
CONSUMER: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Included in this kit:
W750-0127 Wire, 14" (355.6mm) jumper
W750-0285 Wire harness, unit (Electrical Box)
W750-0291 Wire, Switch
W500-0674 5" Restrictor Plate
W175-0309 Connector, reducer 5/8" to 4/7"
NOTE: If you have a circulation blower installed, you will
need to have additional power installed for the operation
of the power vent system.
TERMINAL INSTALLATION
REFER TO GPV INSTALLATION INSTRUCTIONS.
WIRING DIAGRAM AND INSTALLATION
REFER TO GPV INSTALLATION INSTRUCTIONS SECTIONS "SIT 880/886 NOVA FOR USE WITH SINGLE POLE
SWITCH, COMPLETE WITH GPV POWER VENT TERMINAL" OR "SIT 820 NOVA MILLIVOLT FOR USE WITH SINGLE
POLE SWITCH, COMPLETE WITH GPV POWER VENT TERMINAL."
VENTING INSTALLATION
USE ONLY WOLF STEEL APPROVED VENTING COMPONENTS.
REFER TO THE APPLIANCE INSTALLATION INSTRUCTIONS FOR ASSEMBLY AND CLEARANCE REQUIREMENTS.
VENTING LENGTHS
When installing the venting, these parameters supersede the "Vent Installation Section" in the appliance's "Installation
and Operating Instructions," as well as the following guidelines:
All venting confi gurations apply to both top and rear vented units.
Maximum vent run is 60 feet (18.3m) total.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada •
PVA-58ASCENT POWER VENT ADAPTOR KIT
INSTALLATION INSTRUCTIONS
(5/8" ASCENT SERIES)
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
1(866)820-8686 • www.napoleon.com
W415-2981 / 01.06.21