Alarm Recording; Connecting An Alarm Sensor; Setting The Alarm Speed And Duration - Sony SVT-LC300 Mode D'emploi

Alarm Recording

You can use a door switch or alarm sensor to trigger
alarm recording. You can make alarm recording in
recording mode, stop mode and power off mode with
the selected recording speed.

Connecting an Alarm Sensor

Commercially available
switching box, etc.
Setting the Alarm Speed and
Duration
1
1
Press MENU until the SET UP 3 display appears
on the screen.
2
Press SHIFT v to move the flashing to ALARM
SPEED.
<SET UP 3>
ALARM MODE
ALARM SPEED
ALARM DURATION
EXT TIME ADJ.
TAPE IN MODE
TAPE END MODE
TAPE END OUT
CLOG DETECT.
SERIES REC
to ALARM OUT
to COM
to COM to ALARM IN
6
2-5
Y1
6H
20S
01:00
STOP
REW
-3M
Y
N
3
When the TAPE switch is set to T-120:
Set ALARM SPEED to 6H, 18H or NC by
pressing DATA '/'.
6H: for recording in 6-hour mode
18H: for recording in 18-hour mode
NC: for recording at the same speed as before the
alarm was received.
When the TAPE switch is set to T-160:
Set ALARM SPEED to 8H, 24H or NC by
pressing DATA '/'.
8H: for recording in 8-hour mode
24H: for recording in 24-hour mode
NC: for recording at the same speed as before the
alarm was received.-
4
Press SHIFT v to move the flashing to ALARM
DURATION.
<SET UP 3>
ALARM MODE
ALARM SPEED
ALARM DURATION
EXT TIME ADJ.
TAPE IN MODE
TAPE END MODE
TAPE END OUT
CLOG DETECT.
SERIES REC
5
Set ALARM DURATION to 20S, 40S, 1M, 2M,
3M, 5M, CC or TRIG by pressing DATA '/'.
20S/40S - 5M: for recording for 20 seconds, 40
seconds, 1 minute, 2 minutes, 3 minutes or 5
minutes
CC: for recording as long as the alarm signal is
being input
TRIG: for recording from the alarm signal to the
next alarm signal.
Y1
6H
20S
01:00
STOP
REW
-3M
Y
N
27