Nussbaum JUMBO LIFT 3500 NT Mode D'emploi page 84

Made
in
Germany
Time frame Position
Type of
maintenance
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
84
Check electrical components for function and condition.
• Plug.
• Operating lever with button switch.
• During assembly and maintenance always check the condition of electrical
lines. All cables and lines must be secured so they cannot be crushed, kinked
or contact any moving assembly.
Check all fastening screws and anchors with a torque wrench.
Fastening class 8.8
0.08* 0.12** 0.14***
M8 17.9 23.1 25.3
M10 36 46 51
M12 61 80 87
M16 147 194 214
M20 297 391 430
M24 512 675 743
Fastening class 10.9
0.08* 0.12** 0.14***
M8 26.2 34
M10 53 68 75
M12 90 117 128
M16 216 285 314
M20 423 557 615
M24 730 960 1060
* Lubricated slide friction number 0.8 MoS2
** Lightly oiled slide friction number 0.12
*** Ensured slide friction number 0.14 screw with micro-encapsulated plastic
Check the paint:
• Check the powder coating and improve if required.
Damage by external influences is to be treated immediately after detection.
If these points are not treated, infiltration of deposits of all kinds can cause
wide-ranging and permanent damage.
These points are to be lightly sanded (120 grit), cleaned and degreased.
Afterwards, rework with a suitable touch up paint (note the RAL No.).
• Check galvanised surfaces, touch up as needed.
White rust is fostered by permanent humidity, poor ventilation. The affected
areas can be treated by using a sanding cloth (A 280 grit). If required, the
parts are to be treated with a suitable, resistant material (paint etc.). Check
the RAL colour selection.
• Rust is brought out by mechanical damage, wear, aggressive deposits (de-ic-
ing salt, leaking operating fluids) cleaning that is not done or incomplete.
The affected areas can be treated by using a sanding cloth (A 280 grit). If
required, post-treat the areas with a resistant material (paint etc.).
Maintenance plan
37.2
OPI_JUMBO LIFT 3500 NT_V4.0_DE-EN-FR-ES-IT