Maintenance And Care Of The System - Nussbaum JUMBO LIFT 3500 NT Mode D'emploi

Made
in
Germany
Any kind of external leakage is
not permitted and must immedi-
ately taken care of. This is abso-
lutely necessary especially before
an emergency discharge.
Reason which make
necessary are for example, electrical blackout, for errors
in the lowering valves, etc.
1. Switch off the main switch (2).
2. Loosen and remove the front unit covers (1).
3. Unscrew the pins of valves V1 and V2 counter-
clockwise.
2
13
14
2 Main switch
13 Valve V1
4. The lowering process starts immediately.
5. The entire lowering process must continuously be
observed. Observe the reaction of the vehicle.
6. Lower the vehicle to the lowest position.
7. Screw the pins of valves V1 and V2 back in completely.
82
an emergency discharge
5
5 Oil filling opening
14 Valve V2
7 Maintenance and care of the
system
Before maintenance, do all prepa-
ration work so there is no danger
to life or limb or object damage
during maintenance and repair
work.
Value is placed on long lifetimes and safety in the devel-
opment and production of Nussbaum products. To guar-
antee the safety of the operator, product reliability, low
running costs, keep the warranty and also the long-life-
time of the product, proper set up and operation is just
as important as regular maintenance and sufficient care.
The lift system is to be serviced at regular intervals ac-
cording to the following plan. For intensive operation and
higher degree of contamination shorten the service inter-
val.
The complete function of the lift system is to be observed
during daily use. Customer service must be informed of
any malfunctions or leaks.
To simplify maintenance work, follow instructions on the
maintenance sticker that is found somewhere on the unit,
depending on the lift design.
002
OPI_JUMBO LIFT 3500 NT_V4.0_DE-EN-FR-ES-IT