General Information; Hazard Information - Nussbaum JUMBO LIFT 3500 NT Mode D'emploi

Made
in
Germany
1

General information

Technical documentation contains important information
for safe operation and for retaining functional safety of
the system.
• To verify system set up, the set up protocol form is to be
signed and sent to the manufacturer.
• Forms are available in this inspection book for use in ver-
ifying single, regular and extraordinary safety checks.
Use the forms to document inspections and leave the
completed forms in the inspection book.
• The system master forms must record changes to the
construction and changes to set up location.
1.1 Set up and test the system.
Safety relevant work on the system and safety inspections
may only be done by personnel specifically trained to
carry it out. They are designated in general and in this
documentation as technical experts and specialists.
• Technical experts are people (freelance expert engi-
neers, TÜV specialists) that may inspect and assess due
to their education and experience with lift systems. They
are knowledgeable in the appropriate work safety and
accident prevention regulations.
• Specialists (competent people) are people who have
sufficient knowledge and experience with lift systems
and have participated in a special factory training by
the system manufacturer.

1.2 Hazard information

To become aware of the hazardous points and important
information, the following three symbols are used with
the descriptive meaning. Pay particular attention to text
positions that are labelled by these symbols.
i Note! Labels information about a key function or
points to an important remark!
Caution! identifies a warning of possible
!
system damage or other operating compa-
ny property damage if the highlighted pro-
cess is not done properly!
Danger! Identifies a danger to life
and limb, if the highlighted pro-
cess is not done properly there is a
mortal danger!
64 OPI_JUMBO LIFT 3500 NT_V4.0_DE-EN-FR-ES-IT