SPORTSTECH DESK FIT DFT200 Mode D'emploi page 33

WALL MOUNT INSTALLATION
The wall holder can be mounted in two different ways. Either fixed firmly to the wall, or using an adhesive strip
For fixed installation on the wall, please follow these steps:
STEP 1:
Find the appropriate location and height
for your installation, this should be
about 1,285mm from the ground. Mark the
holes to be drilled using a pencil, then drill
the holes for your expansion screws.
HINT:
Using a vacuum cleaner, drilling can be done
without a big deal of dust.
STEP 2:
Try to carefully embed the expansion screw.
STEP 3: Align the expansion screw and finally tighten it.
33
EN