Exploded Drawing/Spare Parts List; Setting Up The Device - SPORTSTECH DESK FIT DFT200 Mode D'emploi

EXPLODED DRAWING/SPARE PARTS LIST

0,3 m
1 m 1 m
2 m
DANGER:
While you program the device and engage in any other preparations, never stand on the
running belt. Always use the side treads instead.
Never operate the device at high speed and never try to jump onto the running belt after-
wards. Always increase speed gradually.
At the following link At the following link
you will find the exploded drawing you will find the exploded drawing
and the spare parts list: and the spare parts list:
https://service.innovamaxx.de/dft200_spareparts https://service.innovamaxx.de/dft200_spareparts

SETTING UP THE DEVICE

Set up the device on a level surface and pay attention to the surrounding clear
space:
1. There must be at least 2 meters of free space at the rear of the device.
2. There must be at least 1 meter of free space on both sides of the device.
3. There must be at least 30cm of free space at the front of the device to allow
the device to be folded up and the power cord to be routed safely.
Do not place the device in front of fume cupboards or ventilation systems.
Do not use the device in a garage, covered courtyard, near water, or outdoors.
28