Ceado G210 Manuel D'utilisation page 54

54
USE
Before first use: rinse all of the parts that will have contact with food in running water i.e.:
spout, juice container, reamers, strainers, splash retainer, splash cover, cones (see Fig. 25
and Fig. 26).
Preparing the Juicer
Before using the juicer for the first time, refer to the "Cleaning and maintenance" section to
clean all parts. Then complete the following steps to prepare the juicer each time you use it:
NOTE: Each time you use the juicer, check to be sure that there are no cracks in the cone,
reamer, or strainer.
1
Place the container onto the base.
2 Check to see that the strainer and spout are not plugged with pulp or seeds from the last use.
Then place the container onto the base.
3
Insert the reamer-strainer into the container over the motor shaft.
Automatic model
Automatic model
4
Place the stainless steel reamer into the container and over the motor shaft. Ensure that the
reamer is seated all the way down on the shaft.
5
Make sure the cone and splash cover are attached tightly to the handle.
6
Place the splash retainer into the container.
Semi-automatic
model
GB
Fig. 27