Ceado G210 Manuel D'utilisation page 40

40
USE
Before first use: rinse all of the parts that will have contact with food in running water i.e.:
inlet, lever, bowl, ice presser cover, blade, water drain.
1
Prepare a container with the ice cubes to be crushed.
2
Place the bowl under the crushed ice spout.
3
Lift up the lever, pour the ice cubes into the inlet.
4
Start the appliance by operating the ON-OFF switch.
5
Lower and push on the lever steadily without forcing.
6
Repeat the above procedure as many times as necessary.
7
After use, stop the motor by turning the switch to "OFF".
NOTE: The lever with the ice presser cover is equipped with a safety microswitch that stops
the motor when the lever is raised (Fig. 11). The fact of lifting the lever to add more ice
cubes in the inlet will therefore stop the motor without switching off the appliance. When the
lever is lowered again the motor starts.
Any attempt to by-pass the safety device may cause personal injury and/or damage to
the appliance.
Position of the
safety
microswitch
GB
Fig. 11