Lavorwash LANDER 2800 Mode D'emploi page 14

fig. 1
S
II. DETERGENT SUCTION
Insert the CHEMICAL nozzle into the lance (fig. 2A).
Plunge suction hose with filter into detergent tank
(fig. 2B). When you start the machine, the mixing of
the detergent with the water is automatic at the wa-
ter passage.
fig. 2A
•CAUTION: make use only of liquid detergent,
do not absolutely use acid or too much alkaline
products. We suggest you to make use of our
products, which have been studied for the use
with washer machines.
III. USE OF THE LANCE
The high-pressure cleaner is supplied with different
nozzle types:
- Low-pressure nozzle (fig. 3A, "CHEMICAL"): for op-
erating with detergent or cleaning with negligible
pressure,
- 0° nozzle: straight stream (fig. 3B) for particularly
stubborn accumulation of grime,
- 15° nozzle: flat spray (fig. 3C) for dirt accumulation
over a large surface,
Optional - 25° nozzle: flat spray (fig. 3D) for dirt ac-
cumulation over a large surface,
Optional - 40° nozzle: flat spray (fig. 3E) for dirt ac-
cumulation over a large surface.
fig. 3A fig. 3B fig. 3C
14
S
fig. 2B
Optional:
fig. 3D fig. 3E
IV. APPLIANCES PROVIDED WITH THERMAL
VALVE
This device enables the machine's by-pass opera-
tion through automatic water discharge whenever
it reaches a temperature of nearly 60°C and cooling
working components.
•CAUTION: appliances that are not provided
with this disposal must not operate for more
than 2 minutes with released gun. Recycled wa-
ter raises its temperature remarkably causing
great damages to the pump.
MONTAGE
Study the series of photos shown below
(pag. 3 , fig. C)
OPERATING INSTRUCTIONS
•CAUTION! Do not run the engine with a high
or low oil level as this can cause engine dam-
age. If you have further questions regarding the
engine, please refer to the engine's operating
manual included with the unit.
•CAUTION! The engine is not provide with oil. It
is necessary to fil the carter before starting the
engine.
•CAUTION! Before starting the pump, check the
oil level in the pump.
•CAUTION! If it is the first time that you use the
machine or if you do not operate the machine
for a long period, it is necessary to connect, for
some minutes, the suction hose, in order to let
possible impurities go out, so that the nozzle
gun will not become clogged.
•CAUTION! Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
I. STARTING UP
WATER SUPPLY
Water supply connection - Additional safety in-
formation
WARNING: (symbol) machine not suitable
for connection to the potable water mains.
•CAUTION:
Water that has flown through back-
flow preventers is considered to be nonpotable.