Scotts LST01540S Manuel De L'utilisateur page 4

UNPACKING
This product requires some assembly.
PACKING LIST
- Power Head
- String Trimmer Attachment
- Safety Guard
- Charger and Battery Pack
- Spool Assembly
- Auxiliary Handle
- Owner's Manual
- Hardware Bag, containing parts as below:
Image Name
Bolt
Nut
Steel Spacer
Socket Screw
Auxiliary
Handle Plate
Wrench
Socket
Spanner
WARNING: Do not install battery until assembly is complete. Failure to
comply could result in accidental starting and possible serious personal
injury.
WARNING: If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this warning could
result in serious personal injury.
Carefully remove the product and any accessories from the box. Make sure
that all items listed in the packing list are included.
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
Do not discard the packing material until you have carefully inspected
and satisfactorily operated the product.
ATTACHING THE GUARD
Assemble the guard as shown below by positioning it onto the trimmer
attachment. Using a Phillips screw driver, secure the guard by installing
three (3) screws into the die cast head. Remove blade cover.
WARNING: Do not operate the trimmer without the guard attached.
Failure to comply could result in possible serious personal injury.
Size Quantity
M5x0.8x35 2 PCS
M5x0.8 2 PCS
N/A 1 PC
M5x0.8x12 3 PCS
N/A 1 PC
T25&+ 1 PC
8mm/10mm 1 PC
Safety Guard
ASSEMBLY
INSTALLING THE STRING SPOOL
Ensure battery pack is removed. Place the steel spacer onto the cutting
head shaft. Align the hole in the spacer with the notched area of the
casting. Insert the wrench provided through the hole in the spacer and
casting to secure the spacer while installing the spool. Twist the spool
onto the bolt in a counter clockwise direction. Make sure the spool is
firmly connected.
Wrench
CUTTING WIDTH ADJUSTMENT
Cutting width can be adjusted to 13" or 15" by positioning the line
cutting blade as shown.
Blade positioned
inside for 13"cut
ATTACHING THE AUXILIARY HANDLE
Install the auxiliary handle and bottom bracket around the shaft of the
power head, at a comfortable distance from the switch trigger. Insert the
four M5.0*0.8*35 bolts into each the four holes. Using the combo tool
provided, tighten the bolts securely so the handle is stationary on the
shaft.
Bolt
4
Model LST01540S
Steel Spacer
Blade positioned
outside for 15"cut