Protections; Configuration Menu; Usb Connectivity - Helvi Explorer 120 Manuel D'instructions

This device is protected against short circuits and polarity reversals. It has an anti-spark system that prevents
sparks when connecting the charger to the battery. The device will not deliver current if there is no battery
detected (no voltage in the clamps). This charger is protected against handling errors by an internal fuse.
Navigation :
1 Press the MODE button for 3 seconds to access the Configuration Menu
2 Use the arrows to scroll through the different parameters
3 Press the SELECT button to select the parameter or enter the submenu.
4 When a parameter is flashing, use the arrows to change its value
5 Confirm the parameter value by pressing SELECT again
Languages :
Selecting the display language.
Sound:
Turning the unit's sound on (ON) or off (OFF).
Auto-Restart:
Enable (ON) or disable (OFF) the AUTO-RESTART function. This function automatically restarts the charger
in the event of a power failure.
Auto-Detect :
Enable (ON) or disable (OFF) the AUTO-DETECT function. This function automatically starts a charge
when a battery is connected to the charger.
Date :
Setting the date and time.
Cable calibration :
Procedure for calibrating the charging cables of the device, so that the charger optimally compensates for
the voltage drop due to the cables. It is strongly recommended to perform this procedure at least once a
year and each time the charging cables are replaced.
Calibration procedure :
1 Press SELECT to enter the CABLE CALIBRATION submenu
2 Short-circuit the clamps
3 Press START/STOP to start the calibration
: The calibration was successful.
4 Err19: Cable_NOK : A problem occurred during cable calibration.
Check that the cables are in good condition and correctly short-circuited and repeat the operation.

USB connectivity :

Sub-menu to access USB features.
Your Explorer 120/130 is equipped with USB connectivity that extends its functionality by creating custom
configurations on your computer that can then be downloaded to the device via a simple USB stick. The
custom configuration allows you to add, delete or modify charging modes and profiles, so that your
charger can be adapted to your needs.
USB connectivity also gives you the ability to retrieve the history and data of more than 100 recharge on
a USB stick and run them on a spreadsheet.
10

PROTECTIONS

CONFIGURATION MENU

USB CONNECTIVITY