Functional Description; Removing/Inserting The Battery - Milwaukee MX FUEL MXF314-0 Manuel De L'utilisateur

FUNCTIONAL DESCRIPTION

7
6
5
4
3
2
1
15
1. Trigger
2. Rear handle
3. Trigger lock
4. Arm button
5. Battery latch lever
6. Battery latch lock
7. Front handle
8. Water supply tube
9. Wheel guard handle
10. Spindle lock access
hole
9
8
14
13
12
18
17
16
11. Water supply valve
12. Quick connect fitting
13. ONE-KEY indicator
™
14. Overheat indicator
15. Spindle bolt
16. Roller wheels
17. Scrench/storage
18. Hex wrench
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push the battery latch to the
side and squeeze the battery latch lever. Pull the
battery pack away from the machine.
WARNING
To insert the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
WARNING
Others may be hazardous.
10
WARNING
maximum safe operating speed at least 5370 RPM.
READ SAFETY INFORMATION SUPPLIED WITH
CUT-OFF WHEEL. Always wear proper safety
equipment, including a dust mask.
Installing and Removing Cut-Off Wheels
1. To install cut-off wheels, remove battery pack.
2. Place machine on a firm surface.
3. Move wheel guard for easier access to spindle bolt.
4. Slide the inner flange, arbor adaptor, cut-off wheel,
and outer flange over the spindle. Be sure the
11
arbor adapter matches the wheel arbor hole size
(20 mm or 1").
Spindle
Inner flange
Arbor adapter
5. While holding the spindle lock in place with the
hex wrench (1), install and tighten the spindle bolt
securely with the scrench (2).
1
2
6. To remove cut-off wheels, hold the spindle lock
in place and loosen the spindle bolt with the
scrench. Remove the spindle bolt, outer flange,
arbor adapter, and cut-off wheel.
5
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this machine.
To reduce the risk of injury, use a
cut-off wheel which is rated with a
Wheel
Outer flange
Bolt