hestan AGPO33LK-TQ Instructions D'installation page 7

ASSEMBLY
(CONT.)
4. Place the small grommet on the cord and slide
and snap into place on the upper part of the
control panel, as shown here. You should still
be able to adjust the cord after installing the
panel to the oven. This grommet is needed to
prevent damage to the cord.
*
Do this for stainless
steel units.
5. Install the control panel flat against the face of the oven. The excess length of the wiring harness
from the frame (assembly step 3) is resting to one side of the oven. If you temporarily re-installed
the left lock-nut (in disassembly step 6) you may remove it now to install this new panel.
USE EXTREME CAUTION WHEN MOUNTING THE PANEL TO AVOID PUSHING THE SPARK USE EXTREME CAUTION WHEN MOUNTING THE PANEL TO AVOID PUSHING THE SPARK
IGNITION MODULE INSIDE THE UNIT. IF YOU DO, YOU WILL HAVE TO REMOVE SEVERAL IGNITION MODULE INSIDE THE UNIT. IF YOU DO, YOU WILL HAVE TO REMOVE SEVERAL
COMPONENTS TO GET INSIDE THE UNIT (see note below). COMPONENTS TO GET INSIDE THE UNIT (see note below).
Carefully install the lock-nuts on the ignition module and gas valve. The ignition module lock-nut
is plastic, use caution. Finger tighten both lock-nuts. You will do a final tightening later.
*
Do this for stainless
steel units.
STONE
RETAINER
SPARK
IGNITION
MODULE
(INSIDE)
DO NOT
PUSH IN !!
SPARK
MODULE CAP
Note: If you mistakenly push the spark module inside the oven, you will need to remove the
stone retainer, ceramic pizza stones, and stone supports to gain access.
KNOB
LOCK-NUTS
SMALL
GROMMET
WIRING
HARNESS
©2022 Hestan Commercial Corporation
EN
G
7