Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DISASSEMBLY
5. The landing ledge may now be removed.
*
For Stainless Steel units,
remove the landing ledge, as
well as this blank panel using
a 2 mm Allen wrench.
Proceed to the next step.
6. Remove the spark module cap and battery, and 2 lock-nuts shown below. Then remove the
control panel.
USE EXTREME CAUTION WITH THE LOCK-NUTS TO AVOID PUSHING THE
USE EXTREME CAUTION WITH THE LOCK-NUTS TO AVOID PUSHING THE
SPARK IGNITION MODULE INSIDE THE OVEN.
SPARK IGNITION MODULE INSIDE THE OVEN
lock-nut to lessen the chance of pushing the ignition module inside the unit.
REMOVE
LOCKNUT
*
For Stainless Steel units,
REMOVE CAP,
do this step and proceed
BATTERY AND
LOCKNUT
to ASSEMBLY step 2.
You will not remove the
front frame.
(CONT.)
FRONT
FRAME
REMOVE THIS
BLANK PANEL
CONTROL
PANEL
FRONT
FRAME
SPARK
IGNITION
MODULE
(INSIDE)
DO NOT
PUSH IN !!
SPARK
MODULE CAP
.
Temporarily re-install and hand tighten the left
LOCK-NUTS
©2022 Hestan Commercial Corporation
EN
LANDING
LEDGE
CONTROL
PANEL
3
Publicité
Table des Matières
