Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
3. Reconnect all the wire harness connections (see photo on page 5). Re-install the ground lug wire
and nut with a 5/16 wrench, and install the assembly inside the frame as shown below. Use caution
to avoid damaging any wires on the sharp edges of the opening. Attach with 2 flat-head screws
EN
provided, using a 2mm Allen wrench.
Temporarily connect the power to verify the light works, then disconnect to continue assembly.
*
Do this for stainless
steel units.
6
©2022 Hestan Commercial Corporation
(CONT.)
If the light does not work, check
the bulb connections are tight (tiny
screws on each side of the ceramic
bulb holder), or replace the bulb
itself with a new G4 "Bi-pin" 20W
halogen bulb. You must loosen the
screws to replace the bulb.
Publicité
Table des Matières
