Setting Date And Time - Tintometer Lovibond MD200 Mode D'emploi

All manuals and user guides at all-guides.com
Menu options
GB
The IRiM Module and the connected printer/PC must be ready. Press
PrtG
the [MODE] key to start the transmitting, the instrument displays
"PrtG" (Printing) for approx. 1 second followed by the number of
the first data set and its transmission. All data sets will be transmit-
ted one after the other. After finishing the instrument switches to
test mode.
The print job can be cancelled by pressing the [On/Off] key. The
On
instrument switches off.
Off
If the instrument is not able to communicate with the IRiM, a timeout
E 132
occurs after approx. 2 minutes. The error E 132 is displayed for approx.
4 seconds. Subsequently, the instrument switches to test mode (see
also IRiM manual).
Store Date
2
2
3
Time Cal
After confirming the selection with the [MODE] key the value to be
Mode
edited will be shown for 2 sec.
The setting starts with the year (YYYY) followed by the actual value to
SET
be edited. The same applies for month (mm), day (dd), hour (hh) and
DATE
minutes (mm). Set the minutes first in steps of 10, press the [!] key to
continue setting the minutes in steps of 1.
YYYY
(2 sec.)
Increase the value by pressing the [MODE] key.
Mode
Zero
Decrease the value by pressing [ZERO/TEST] key.
Test
!
Proceed to the next value to be edited by pressing [!] key.
After setting the minutes and pressing the [!] key the display will show
"IS SET" and the instrument returns to the measurement mode.
MD200_1 09/2011
notch for IR
data transfer
3 Setting date and time (24-hour-format)
29