How To Use The Machine; Safety Recommendations; Why The Safety Devices Cut In - Dolmar TM-98.14 H2D Manuel D'utilisation

Masquer les pouces Voir aussi pour TM-98.14 H2D:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

HOW TO USE THE MACHINE

5.
HOW TO USE THE MACHINE

5.1 SAFETY RECOMMENDATIONS

DANGER!
!
which it was designed (cutting grass).
Do not tamper with or remove the safety devices fitted to the machine.
REMEMBER THAT THE USER IS ALWAYS RESPONSIBLE FOR DAMAGE
AND INJURIES TO OTHERS. Before using the machine:
– read the general safety regulations ( ☛ 1.2), paying particular attention
to driving and cutting on slopes;
– carefully read the instructions for use, become familiar with the controls
and on how to quickly stop the blades and engine;
– never put your hands or feet next to or beneath the rotating parts and
always keep away from the discharge opening.
Do not use the machine when in a precarious state of health or under the
effect of medicines or other substances that can reduce your reflex
actions and your ability to concentrate.
It is the user's responsibility to assess the potential risk of the area where
work is to be carried out, as well as to take all the necessary steps to
ensure his own safety and that of others, particularly on slopes or rough,
slippery and unstable ground.
Do not leave the machine stopped on high grass with the engine running
to avoid the risk of starting a fire.
WARNING!
!
10° (17%) ( ☛ 5.5). If the machine is likely to be used mostly on sloping
ground (never above 10°), fit counterweights (supplied on request ☛ 8.1)
beneath the cross-member of the front wheels which improve stability at
the front and reduce the chance of tipping up.
IMPORTANT
those described in chapter 4.

5.2 WHY THE SAFETY DEVICES CUT IN

The safety devices work in two ways
– by preventing the engine from starting if all the safety requirements have not
been met;
The machine must only be used for the purpose for
This machine must not be used on slopes greater than
All the references relating to the positions of controls are
EN 17

Publicité

Table des Matières
loading

Table des Matières