Closing The Door - ARTHUR MARTIN ARB5000AOW Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
There is too much frost
and ice.
Water flows inside the
refrigerator.
Door is misaligned or
interferes with ventilation grill.
The temperature in the
appliance is too low/too high.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defectivedoor
gaskets. Contact the ServiceCenter.
Possible cause
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correctly.
The door is not closed correctly
or the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set
incorrectly.
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
The appliance is not levelled.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
Solution
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Refer to "Levelling".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products
temperature decrease to room
temperature before storage.
Store less food products at the
same time.
Defrost the appliance.
Make sure that there is cold air
circulation in the appliance.
9

Publicité

Table des Matières
loading

Table des Matières