ARTHUR MARTIN ARB5000AOW Notice D'utilisation page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Take the door off.
4. Unscrew the two screws fixing the
lower door hinge (there is a foot fixing
on the hinge, do not remove it from the
hinge). Take the door off.
2
5. Then remove the left foot as shown in
the figure.
6. Fix the door hinge (with the original
foot on it) on the opposite side and
then the loosened foot at the former
place as shown in the figure. Make
sure to place the screws in the right
holes as shown in the figure.The edge
of the hinge is parallel with the side of
the cabinet.
7. Fix the door onto the lower hinge pin.
8. To fit top door hinge, remove the
plastic screw hole cover carefully, and
refit them in the holes left by the hinge
retaining screws.
9. Refit the top hinge using the 2
retaining screws, making sure that the
edge of the door is parallel with the
side of the cabinet.
10. Replace the hinge cover.
11. Relocate the handle and the plastic
plugs to the opposite side.
1
1
WARNING! Reposition, level the
appliance, wait for at least four
hours and then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket. In case you do
not want to carry out the above mentioned
operations, contact the nearest After Sales
Service Force. The After Sales Service
specialist will carry out the reversibility
of the doors at your cost.
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on
the rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided with
a contact for this purpose. If the domestic
power supply socket is not earthed,
connect the appliance to a separate earth
in compliance with current regulations,
consulting a qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
11
2
3

Publicité

Table des Matières
loading

Table des Matières