Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
No audio output.
Timer lamp fl ickers
Timer recording does not work properly.
The remote control doesn't work.
I forgot my password for parental
supervision
Is it possible to change a subtitle and an
audio signal on a recorded disc?
Other problems
EXPLANATION/SOLUTION
Check whether you have selected the correct digital output options in the Audio
Output Options menu. (See pages 34~35)
•
Check there is enough space in the disc or HDD for recording.
•
Check whether the current disc is recordable or not.
Make sure to check before the start time of recording.
•
Re-check the recording time and the end time settings again.
•
Recording will be cancelled if the power is interrupted due to a power failure
or another similar reason while recording.
•
Point the remote control at the remote control sensor on your HDD & DVD
RECORDER. Allow for proper distance. Remove obstacles between your HDD
& DVD RECORDER and the remote control.
•
Check whether the batteries are drained.
•
Check the TV/DVD selection button setting.
•
Check whether TV control button is selected or not.
Press and hold the PLAY/PAUSE (&) buttons on the front panel for more than
10 seconds with no disc in the unit.
All settings including the password will revert to the factory settings. Do not use
this unless absolutely necessary.
A recorded disc is played with only the subtitle and the audio signal which were
selected during recording
•
Read the table of contents and then fi nd and read the section describing your
problem, follow the instructions given.
•
Plug your HDD & DVD RECORDER off and on.
•
If the problem still persists, contact a nearby Samsung service centre.
English _93
Publicité
Table des Matières
