Using The Showview Feature - Samsung DVD-HR770 Mode D'emploi

recording

USING THE SHOWVIEW FEATURE

Before setting your HDD & DVD Recorder to record.
•
Switch on both the television and your HDD & DVD RECORDER.
•
Check that the date and time are correct.
Up to twelve programmes can be set to record.
1. With the unit in Stop mode, press the TIMER button.
2. Press the ▲▼ buttons to select ShowView, then press the OK or
► button.
•
A message is displayed to allow you to enter the ShowView
code.
3. Press the number buttons to enter the code of the programme that
you want to record in your television magazine.
•
If you want to correct the ShowView code that you are entering:
- Press the ◄ button until the digit to be corrected is cleared.
- Enter the correct digit.
4. Press the OK button.
•
The information concerning the programme is displayed.
•
When using the ShowView function for the fi rst time with stored
stations, the programme number fl ashes. This one time, you
must enter the PR number manually by pressing the ▲▼
buttons.
5. Press the RED(A) button if you do not want to use the default title
name.
The rename screen is displayed.
Follow steps 4 and 5 of "Renaming (Labelling) a Title" on pages
73~74.
6. If the programme and times are correct, press the OK button.
7. Turn the power off by pressing the STANDBY/ON button to
activate the timer recording setting.
•
Refer to pages 69 and 71 if you want to
- Check whether the timer Recording has set correctly or not.
- Cancel a preset recording.
M

The numbers next to each TV programme listing in the magazines or newspapers are ShowView code numbers,
which allow you to programme your HDD & DVD RECORDER. instantly with the remote control. Enter the ShowView
code for the programme you wish to record.

ShowView is a trademark of Gemstar Development Corporation. The ShowView system is manufactured under
licence from Gemstar Development Corporation.
70_ recording
SXCV
HDD & DVD RECORDER
HDD
ShowView
Library
Scheduled List
Timer Record
ShowView Extended : Off
Disc Manager
Recorded List
Setup
m s r
MOVE SELECT RETURN
HDD & DVD RECORDER
HDD
Library
Timer Record
Enter ShowView Code number. [0-9]
I I I I I I I I I I I I I I I I
Disc Manager
Setup
(Press [OK] button: Make Code.)
s r
0~9 NUMBER SELECT RETURN
HDD
Current Time 10:54
No. To Source Date Start End Mode VPS/PDC
No. 01 No Title
Add a list
To Source Date Start End Mode VPS/PDC
HDD – – JAN 01 10 : 54 12 :54
Title s Save
Recordable Time HDD 108:14 SP
Recordable Time HDD 108:14 SP
Recorded List
< s r
MOVE SELECT RETURN
Timer Record
|
|
|
|
e
EXIT
ShowView
I I
e
EXIT
Scheduled List
SP On
e
EXIT