Using The Showview Feature - Samsung DVD-HR749 Manuel D'instructions

HDD & DVD RECORDER Timer Record
HDD
ShowView
Library
Scheduled List
Timer Record
ShowView Extended : Off
Disc Manager
Recorded List
Setup
m MOVE s SELECT r RETURN e
HDD & DVD RECORDER ShowView
HDD
Library
Timer Record
Enter ShowView Code number. [0-9]
I I I I I I I I I I I I I I I I I I
Disc Manager
Setup
(Press [OK] button: Make Code.)
0~9 NUMBER SELECT RETURN
s r e
HDD Scheduled List
Current Time 10:54
No. To Source Date Start End Mode VPS/PDC
No. 01 No Title
Add a list
To Source Date Start End Mode VPS/PDC
HDD – – JAN 01 10 : 54 12 :54 SP On
Title s Save
Recordable Time HDD 108:14 SP
Recordable Time HDD 108:14 SP
Recorded List
MOVE SELECT RETURN
< s r e

Using the ShowView Feature

|
|
|
|
Before presetting your HDD & DVD RECORDER.
• Switch on both the television and your HDD & DVD RECORDER.
EXIT
• Check that the date and time are correct.
Up to twelve programmes can be preset
1. With the unit in Stop mode, press the MENU button.
Press the ▲▼ buttons to select Timer Record, then press the OK
2.
or ► button.
Press the ▲▼ buttons to select ShowView, then press the OK or ►
3.
EXIT
button.
• A message is displayed to allow you to enter the ShowView code.
4. Press the number buttons to enter the code of the programme that
you want to record in your television magazine.
• If you want to correct the ShowView code that you are entering:
Press the ◄ button until the digit to be corrected is cleared.
-
EXIT
- Enter the correct digit.
5. Press the OK button.
• The information concerning the programme is displayed.
• When using the ShowView function for the fi rst time with stored
stations, the programme number fl ashes. This one time, you must
enter the PR number manually by pressing the ▲▼ buttons.
6. Press the RED(A) button if you do not want to use the default title
name.
The rename screen is displayed.
Follow steps 4 and 5 of "Renaming (Labeling) a Title" on page 73.
7. If the programme and times are correct, press the OK button.
8. Turn the power off by pressing the STANDBY/ON button to activate
the timer recording setting.
• Refer to pages 69, 71 if you want to
- Check whether the timer Recording has set correctly or not.
- Cancel a preset recording.
M

The numbers next to each TV programme listing in the
magazines or newspapers are ShowView code numbers,
which allow you to programme your HDD & DVD RECORDER.
instantly with the remote control. Enter the ShowView code for
the programme you wish to record.

ShowView is a trademark of Gemstar Development
Corporation. The ShowView system is manufactured under
licence from Gemstar Development Corporation.
English - 70
SXCV