Bestron AWH2000 Mode D'emploi page 32

Warm air
Switch on the device by pressing the ON/OFF button on the remote control. Then press MODE. The device
will provide warm air, 1 heat lamp
Hot air
Switch on the device by pressing the ON/OFF button on the remote control. Then press MODE twice. The
device will provide hot air, 2 heat lamps switch on
Switch on quickly
To switch the device on quickly with warm air, press the QuickStart button on the back of the device.
OPERATION - Setting the temperature
1. Switch on the device by pressing the ON/OFF button on the remote control.
2. Then press - or + to decrease or increase the temperature.
The first 2 digits on the display indicate the current temperature. The last 2 digits indicate the desired
temperature.
When it reaches the desired temperature, the automatic thermostat ensures that the room stays at the set
temperature. The first 2 digits on the display may occasionally deviate by a few degrees. This is normal.
OPERATION - Using the power-off timer
The power-off timer allows you to set the appliance to switch off automatically after a set time.
1. Switch on the device by pressing the ON/OFF button on the remote control.
2. Press 24H on the remote control.
3. Press 24H again to increase the set time by 1 hour at a time.
The device will switch off automatically after the set time.
OPERATION - Set the current day and time
1. Switch on the device by pressing the ON/OFF button on the remote control.
2. Press SET on the remote control.
3. Then press - or + to set the day of the week.
(Mon = 1, Tue = 2, Wed = 3, Thu = 4, Fri = 5, Sat = 6, Sun = 7).
4. Press SET again.
5. Then press - or + to set the hours.
6. Press SET again.
7. Press – or + to set the minutes.
8. Press SET again.
WARNING:
If you switch off the device with the Standby switch on the back, all settings will be lost. You must then enter
all settings again to use the weekly timer.
OPERATION - Using the timer
With the week timer you can have the device automatically switched on and off at different times every
weekday. Before using the weekly timer, you must set the current day and time. See the above chapter.
1. Switch on the device by pressing the ON/OFF button on the remote control.
2. Press TIMER on the remote control. The display shows the number 1, which means that you can now
set the power-on time for Monday.
switches on and the ventilation light
and the ventilation light
32
switch on.
switch on.
EN