afriso RG 210 Manuel D'utilisation page 51

5.2 Mounting the product
5.2.1 Level controllers
1. Loosen the screws at the product.
2. Remove the upper part of the housing.
3. Mount the base to the wall.
4. Connect the product electrically, see chapter "Electrical connection".
5. Select the operating mode, see chapter "Setting the operating mode".
6. Fit the upper part of the housing to the base.
- Verify that the contact bar of the printed circuit board does not damage
the contact springs of the base.
7. Mount the upper part of the housing with the screws.
Mounting
RG 210
EN
19