Sauder Executive Desk 412902 Instructions De Montage page 2

Table of Contents
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Part Identifi cation
å
While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts.
A OUTER END (2)
B3 RIGHT END (1)
C3 LEFT END (1)
D2 RIGHT UPRIGHT (1)
D32 LARGE LEFT DRAWER SIDE (2)
D33 LARGE RIGHT DRAWER SIDE (2)
D34 SMALL RIGHT DRAWER SIDE (2)
D35 SMALL LEFT DRAWER SIDE (2)
D36 RIGHT DRAWER SIDE (2)
D37 LEFT DRAWER SIDE (2)
D74 SMALL DRAWER BACK (2)
D77 DRAWER BACK (2)
D78 LARGE DRAWER BACK (2)
D708 LARGE DRAWER BOTTOM (2)
D716 DRAWER BOTTOM (4)
E2 LEFT UPRIGHT (1)
Page 2
Assembly Tools Required
2-4
5-7
8-40
41-46
47-52
53-54
55
F2 TOP (1)
G2 BOTTOM (2)
H2 MODESTY PANEL (1)
I BACK (1)
J PEDESTAL BACK (1)
K BRACE (4)
L DOOR (1)
M ADJUSTABLE SHELF (1)
M26 MOLDING (4)
N SKIRT (4)
O KEYBOARD FRONT (1)
P KEYBOARD BACK (1)
Q KEYBOARD SIDE (2)
R KEYBOARD SHELF (1)
S LARGE DRAWER BOX FRONT (2)
T LARGE RIGHT DRAWER FRONT (1)
412902
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Hammer
Not actual size
Skip the power trip.
This time.
U LARGE LEFT DRAWER FRONT (1)
Z DRAWER BOX FRONT (2)
AA RIGHT DRAWER FRONT (1)
BB LEFT DRAWER FRONT (1)
DD PLINTH (8)
FF SMALL RIGHT DRAWER FRONT (1)
GG SMALL LEFT DRAWER FRONT (1)
LL TOP REAR MOLDING (1)
MM UPPER BACK MOLDING (1)
NN SIDE MOLDING (2)
OO LOWER MOLDING (1)
PP UPPER MOLDING (1)
RR LEFT BOTTOM MOLDING (2)
TT RIGHT BOTTOM MOLDING (2)
UU TOP FRONT MOLDING (1)
VV HALF DISK (8)
www.sauder.com/services