Bosch SHEM78WH5N Notice D'utilisation page 44

en-us Troubleshooting
Fault Cause
Error code Supply voltage too low.
: is lit.
A different A technical fault has probably
error code is occurred.
indicated on
the digital
display.
( : to
: )
Home network Wi-Fi is not active on the router.
is not loading.
Wi-Fi display Connection to the home network is
flashes not available.
Home Connect Possible setting errors or a
cannot be technical fault.
implemented
correctly.
Refill indicator No rinse aid.
for salt P
No salt.
and/or
Sensor does not detect salt tablets. Use different dishwasher softener salt.
rinse-aid H
is lit.
Refill indicator Refill indicator switched off.
for salt P
and/or
rinse-aid H
There is still enough special
is not lit.
salt/rinse aid available.
Water is left in Filter system or area under the
the dishwasher filters 1b is blocked.
at the end of
Wash cycle has not ended yet.
the wash cycle.
44
Remedial action
Not a dishwasher fault, have the supply
voltage and electrical installation checked.
Switch off dishwasher with the On/Off
switch (. After a short time restart the
dishwasher.
If the problem recurs, turn off the tap and
pull out the power supply plug.
Call customer service and mention the error
code.
Check the wireless network connection of
your router.
Activate the wireless network on your
router.
Observe the supplied documents and
support information for Home Connect.
Refill rinse aid.
Refill with dishwasher softener salt.
Activation/deactivation
on page 21, "+ Water softening
system / special salt" on page 19
Check refill indicator, levels.
Clean filters and area underneath.
Wait until wash cycle ends or reset.
", Rinse Aid"