Bosch SHEM78WH5N Notice D'utilisation page 20

en-us Water softening system / special salt
Top off the salt as follows:
Undo the screw plug on the
1.
dispenser 1Z.
Fill the dispenser with water
2.
(required only when switching on
the appliance for the first time).
Add salt as illustrated (do not use
3.
table salt, salt tablets or salt for
use with whole house water
softeners).
The water is displaced and runs
out.
For more information about buying
dishwasher salt, please contact
customer service (1-800-944-2904).
Using detergents with salt
component
If combined detergents with a salt
s a l t c o m p o n e n t D e t e r g e n t w i t h a
component are used, special salt can
usually be omitted up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l). If the water
hardness is over 21° dH, salt must
be used.
20
Switching off low salt
indicator / water softening
system
If the use of combined detergents
s t e m t e r s o f t e n i n g s y S w i t c h i n g o f f w a
with a salt component impairs the
low salt indicator P on the control
panel or the text on the display
window at the top @ (enough salt
for x rinse cycles), the displays can
be switched off.
Proceed as described under "Setting
water softening system" and set the
value to 0-8. The water softening
system and salt refill indicator
are now switched off.