Ezviz T1 Mode D'emploi page 80

Setting the Working Mode
Normal Mode (Default):
In this mode, if the detector gets triggered several times within 1 minute,
it sends the first detected alarm to EZVIZ app. If the detector gets
triggered 1 minute later from the first alarm, another alarm signal is sent.
Example: If the detector gets triggered at 10:00:00, 10:00:50,10:01:01,
and 10:02:05, the detector sends three alarms at 10:00:00, 10:01:01, and
10:02:05 to the EZVIZ app.
Dynamic Mode (Applicable to Crowded Places):
Turn the terminal 3 of SW2 to ON to switch to the Dynamic Mode. In this
mode, if the detector gets triggered several times within 1 minute, it
sends the first detected alarm to EZVIZ app. If the detector gets triggered
1 minute later from the last alarm, another alarm signal is sent.
Example: If the detector gets triggered at 10:00:00, 10:00:50,10:01:01,
and 10:02:05, the detector will send the alarms at 10:00:00 and 10:02:05
to the EZVIZ app.
75