Door Closing - KitchenAid KUWO24LSBX Guide D'utilisation Et D'entretien

2. Insert the overlay hooks into the top of the holes in the door.
Push against the overlay frame to force the overlay hooks
deeper into the door. Pull the overlay frame straight down to
secure the overlay hooks to the door.
3. Using a Phillips screwdriver, attach the overlay plates to the
bottom of the overlay frame and door as shown.
A B
A. Overlay frame
B. Door
C. Overlay plates (2)
D. Round-head screws (8)
Install the Door
IMPORTANT: To ensure proper operation, be sure to grease the
top hinge, top spacer and washer with petroleum jelly.
1. Using a Phillips screwdriver and three screws, attach the top
spacer to the door.
2. Using petroleum jelly, grease the bottom spacer hole and the
bottom hinge pin. Align the washer with the bottom spacer
hole.
3. Slowly lower the door straight and evenly onto the bottom
hinge pin. Be sure the washer stays in place. Close the door.
Be sure the door properly aligns to the cabinet.
NOTE: Provide additional support for the door when moving
the hinges. Do not depend on the door magnets to hold the
door in place while you are working.
4. Using masking tape, secure the door to the cabinet before
installing the top spacer as shown.
A. Top spacer
B. Masking tape
5. Place the washer on the top spacer and align the holes.
Grease the top hinge pin, top spacer and washer with
petroleum jelly. Insert the top hinge pin into the washer and
top spacer.
C D
6. Using a Phillips screwdriver and three screws, attach the top
hinge to the cabinet as shown.
A. Screws (3)
B. Top hinge
C. Washer
7. Remove the masking tape from the door.

Door Closing

Your wine cellar has four leveling legs. If your wine cellar seems
unsteady or you want the door to close more easily, adjust the
wine cellar's tilt using the instructions below.
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
A
Do not use an extension cord.
Failure to follow these instructions can result in death,
B
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
2. Move the wine cellar into its final location.
3. Turn the leveling legs to the right to lower the wine cellar or
turn the leveling legs to the left to raise it. It may take several
turns of the leveling legs to adjust the tilt of the wine cellar.
D. Top spacer
E. Door
F. Overlay frame
Door Closing
WARNING
Electrical Shock Hazard
WARNING
Excessive Weight Hazard
A
B
C
D
E
F
7