Install Custom Overlay Frame; Important; Unpack The Wine Cellar - KitchenAid KUWO24LSBX Guide D'utilisation Et D'entretien

Unpack the Wine Cellar

WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the wine cellar. Rub a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your wine cellar. For
more information, see "Wine Cellar Safety."
Dispose of/recycle all packaging materials.
When Moving Your Wine Cellar:
Your wine cellar is heavy. When moving the wine cellar for
cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the wine cellar straight out when moving it. Do not wiggle
or "walk" the wine cellar when trying to move it, as floor
damage could occur.
Clean Before Using
After you remove all of the packaging materials, clean the inside of
your wine cellar before using it. See the cleaning instructions in
"Wine Cellar Care."

Install Custom Overlay Frame

IMPORTANT:

Create custom overlay frame according to the specifications
in the "Custom Overlay Frame" section.
KitchenAid is not responsible for the removal or addition of
molding or decorative panels that would not allow access to
the appliance for service.
Remove the Door
IMPORTANT: Do not remove the grease from the washer, top
spacer or top hinge pin. Be sure to set aside the top hinge, top
spacer and washer for later use.
1. Using a Phillips screwdriver, remove the three screws from the
top hinge. Remove the top hinge.
6
A. Screws (3)
B. Top hinge
C. Washer
2. Remove the three screws from the top spacer. Remove the
top spacer and washer.
3. Open the door. Lift the front of the door up, pulling straight out
to remove as shown.
Attach the Overlay Frame
NOTE: If the overlay hooks are not installed, see "Custom Overlay
Frame" for overlay hook locations.
1. Position the overlay frame ¹⁄₂" (1.27 cm) higher than the door.
Be sure to position the overlay hooks to the pilot holes.
A
B
C
D
E
D. Top spacer
E. Door