Chauvet DJ abyss USB Guide De Référence Rapide page 4

Abyss™ USB QRG
Mounting
Product
Mounting
Diagram
D-Fi™ USB
Connectivity
DMX Linking
Starting
Address
Master/Slave
Connection
Before mounting this product, read the
Clamp
(such as the CLP-15N
from Chauvet)
Mounting Bracket
Bracket Adjustment
Knob (x2)
The Abyss™ USB is able to become a D-Fi™ wireless receiver/transmitter with
the use of the D-Fi™ USB from CHAUVET® DJ. Simply set the DIP switch
D-Fi™ receiving/transmitting channel, plug it into the USB port then set the
product's DMX Personality and DMX Address. Further instructions for connecting
and configuring this product for D-Fi™ USB operation are in the User Manual.
WARNING! DO NOT plug anything other than a D-Fi™ USB into the USB
port. Doing so may cause damage to the product.
Once plugged in, the D-Fi™ USB will take over the product. Wired DMX,
manual display control/menu buttons and IRC-6 will be unavailable until you
unplug the D-Fi™ USB. The priority levels are:
1. D-Fi™ USB
2. Wired DMX
3. IRC-6 Remote Control
4. Manual Digital Display / Menu Buttons
The Abyss™ USB can work with a DMX controller when linked by DMX
serial connections. Instructions for connecting and configuring this product for
DMX operation are in the User Manual. If you are not familiar with DMX,
download the DMX Primer from www.chauvetlighting.com.
To ensure full access to all channels in each DMX mode, the highest
recommended DMX address is 510.
The Abyss™ USB uses the DMX data connection for its Master/Slave mode.
Instructions for connecting and configuring this product for Master/Slave operation
are in the User Manual.
Safety
4
Notes.
Safety Cable
(such as CH-05
from Chauvet)
EN